if (this.Model.StructuredPageData.IsNotBlank() && (this.Model.StructuredPageData.IndexOf(availabilityKey) != -1 || this.Model.StructuredPageData.IndexOf(priceKey) != -1))
{
this.Model.StructuredPageData = string.Empty;
//}
}
Tomahawk 521-820 Stub Out Bracket, 25 lb, Steel, Copper Plated, Domestic
SIOUX 521-820 1-3/4 X 20 CU PLATED BRACKET
Pipe Support Brackets
}
Tomahawk 521-820 Stub Out Bracket, 25 lb, Steel, Copper Plated, Domestic
106367
MFG #: 521-820
Product ID:106367
Famous Supply
- Dimensions: 20 in L x 1-3/4 in H
- Series: 521
- Load Capacity: 25 lb
- Material: Steel
- Finish: Copper Plated
- Domestic/Import: Domestic
Sioux Chief's copper plated stub out bracket shall be used where necessary to support 1/2, 3/4 or 1 in nominal copper stub outs for water supply lines. Holes for positioning copper tube shall be located on 2 in or 4 in center lines depending on model number. Bracket shall be produced from cold-roll steel, copper plated and include aprotective water based clear coat finish to minimize surface rust when arriving at jobsite. Depending on model number, bracket may feature extruded holes, providing a wider soldering surface. Bracket may also feature rolled edges to provide additional strength.
- Features
- Standards & Approvals
| Extruded model provides four time the soldering surface for extra strength |
| Heat the tube, not the bracket |
| Using approved hardware, secure bracket with nail or screw to stub through pilot hole |
| Insert copper stub out into pipe hole, apply flux and solder copper making sure to heat the tube, not the bracket |
| Excessive heat applied directly to bracket could result in burning off the plated finish |
| 1/2 in hole on 2 in center and 3/4 in and 1 in hole on 4 in center, extruded hole with rolled edge |
| 24 ga steel |
| IAPMO Certified |
| UPC Listed |