if (this.Model.StructuredPageData.IsNotBlank() && (this.Model.StructuredPageData.IndexOf(availabilityKey) != -1 || this.Model.StructuredPageData.IndexOf(priceKey) != -1))
{
this.Model.StructuredPageData = string.Empty;
//}
}
Reznor WS23/33 WS Series Single-Phase Hydronic Unit Heater, 115 VAC, 0.02 to 0.055 hp, 330 to 500 cfm, 16-7/16 in W x 16-7/16 in H x 18-5/16 in D
REZNOR WS-23/33 HORIZONTAL/VERTICAL SUSPENDED HYDRONIC UNIT HEATER 115/1 HOT WATER ONLY
Hydronic Unit Heaters
}
Reznor WS23/33 WS Series Single-Phase Hydronic Unit Heater, 115 VAC, 0.02 to 0.055 hp, 330 to 500 cfm, 16-7/16 in W x 16-7/16 in H x 18-5/16 in D
108578
MFG #: WS-23/33
Product ID:108578
Famous Supply
- Amperage Rating: 0.9
- Fan Guard Type: Galvanized
- Material: Steel
- Series: WS Series
- Type: Single-Phase
- Voltage Rating: 115
- Horsepower: 0.02 to 0.055
- Flow Rate: 330 to 500 cfm
- Height: 16-7/16 in
- Width: 16-7/16 in
- Depth: 18-5/16 in
Reznor model WS steam/hot water suspended heaters are design-engineered to be technically advanced and aesthetically pleasing which makes it the hydronic heater for the 21st century. This smart new concept in commercial heating units will accommodate all architects who are looking for something new and attractive.
- Features
- Standards & Approvals
- Application
| The heat exchanger is made of one or two rows of coils with aluminum fins, with approximately 10-1/2 fins per in |
| The spacing between the fins makes cleaning and maintenance of the heat exchanger easier, which is essential to keep the unit heater efficient |
| The standard steel tubing is very strong and long lasting |
| Steel tubing is designed for hot water applications up to 150 psi |
| The copper tubing used for the heating coil is very thick (0.03 in), making Reznor heating coils extremely sturdy and long lasting |
| The large tube diameter reduces the water pressure drop, which means these units require lower pump pressure than other hydronic heaters |
| It also allows a very rapid heat radiation |
| Heat exchangers are subjected to a pressure test at over 350 psi (25 bar) before leaving the factory |
| The standard 2-speed motor is a hermetically sealed motor which is maintenance free |
| The motor is wired for 115/1/60 supply voltage |
| The motor speed is field adjustable to run at high or low RPMs |
| The flexibility of changing motor speeds allows the installer to adjust the unit to high speed for increased Btu/hr output or low speed for reduced noise level |
| All motors have internal protection as a standard feature |
| All model WS units can be installed for either vertical or horizontal |
| Heat exchanger composed of one or two rows of steel tubes and aluminum fins spaced approximately 10-1/2 fins per in |
| Painted tubing heat exchanger and aluminum fins, hot water source |
| Fan/motor assembly includes galvanized fan guard |
| Vertical or horizontal configuration |
| Cabinet and louvers constructed of galvanized pre-painted steel |
| Cabinet held together by shake-proof screws and molded corner sections |
| ISO 9001 Registered |
| For Steam Heating Applications |